| |
| |
|
|
A BILL TO BE ENTITLED
|
|
|
AN ACT
|
|
|
relating to requirements for a voting system to be used in an |
|
|
election in this state. |
|
|
BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF TEXAS: |
|
|
SECTION 1. Section 122.032, Election Code, is amended by |
|
|
amending Subsection (a) and adding Subsection (c) to read as |
|
|
follows: |
|
|
(a) For a voting system or voting system equipment to be |
|
|
approved for use in elections, the voting system in which the |
|
|
equipment is designed to be used must: |
|
|
(1) comply with the standards prescribed by Subchapter |
|
|
A; and |
|
|
(2) beginning September 1, 2021, have: |
|
|
(A) all software used in the voting system be |
|
|
developed and operated entirely within [be manufactured, stored, |
|
|
and held in] the United States and sold by a company whose: |
|
|
(i) [(A)] headquarters are located in the |
|
|
United States; and |
|
|
(ii) [(B)] parent company's headquarters, |
|
|
if applicable, are located in the United States; and |
|
|
(B) all hardware used in the voting system, if |
|
|
manufactured outside the United States, be delivered to the United |
|
|
States without any embedded software installed. |
|
|
(c) In this section, "embedded software" means programmable |
|
|
instructions provided on software that is delivered with voting |
|
|
system equipment or with a replacement part for that equipment for |
|
|
the purpose of equipment operation, including all relevant patches |
|
|
and fixes made by the original equipment manufacturer of the voting |
|
|
system equipment or replacement part for that purpose. |
|
|
SECTION 2. This Act takes effect on the 91st day after the |
|
|
last day of the legislative session. |